Fabric & Upholstery

How to Get Grease Stains Out of Fabric Throw Pillows

Grease on a throw pillow usually comes from hands, hair, lotion or a plate of food, and it behaves nothing like a coffee spill. Oil and water repel each other, so dabbing with a wet cloth spreads the grease and drives it into the weave instead of lifting it. The sequence that works is absorb first, emulsify second, rinse last, and it matters whether the pillow has a removable cover or is sewn shut.

The other variable is the insert. A feather or down insert holds moisture and odor, while a polyester fiberfill insert dries quickly but clumps if it gets soaked. Cleaning is therefore a decision about three things at once: the cover fiber, the cleaning code and whether the insert can be separated. In most cases the cover comes off and the insert never sees water at all.

What You'll Need

Gather everything before you start so the surface is never left half-treated.

  • Cornstarch (or baking soda as a backup)
  • Mild dish soap
  • Warm water
  • Two bowls and a whisk
  • White cloths
  • Soft brush
  • Vacuum with an upholstery attachment
  • Fan or open window
  • Laundry mesh bag, if the cover is washable

Safety first: Check the care label on the cover and on the insert before cleaning, and test any detergent on an inside seam. Never put a feather or down insert in a washing machine unless its label specifically allows it, and dry foam pillows completely before use to prevent mildew.

Step-by-Step Guide

  1. 1

    Separate the cover from the insert.

    Unzip the cover and set the insert aside. If the pillow is sewn shut, the whole item has to be cleaned in place, which changes the method to foam and blotting rather than washing. Knowing this before you start prevents a soaked insert you cannot dry.

  2. 2

    Read the label on both parts.

    The cover may be machine washable, dry-clean only or spot-clean only, and the insert may have its own instructions. A W code on upholstery fabric means water-based cleaners are fine; an S code means solvent only. For a sewn pillow with no label, treat it as S.

  3. 3

    Vacuum the surface first.

    Run the upholstery attachment over both sides to pull out dust and crumbs. Grease traps grit, and that grit becomes an abrasive paste the moment you start rubbing. Vacuuming also fluffs the fabric so the absorbent powder can reach the fibers.

  4. 4

    Draw the oil out with cornstarch.

    Pile cornstarch about a quarter inch thick over the grease mark and press it in gently with your fingers. Leave it for twenty to thirty minutes, then brush it away. Cornstarch is a fine absorbent powder that pulls surface oil out before any liquid is added; baking soda works as a substitute but is more alkaline.

  5. 5

    Emulsify with dish soap foam.

    Whisk a teaspoon of mild dish soap into half a cup of warm water until it foams, then pick up only the foam with a cloth. Press it into the mark and let it sit for five to ten minutes. Dish soap is a surfactant: one end grabs oil, the other grabs water, which is how the grease is finally lifted.

  6. 6

    Blot, then move to a clean area of cloth.

    Press straight down with a dry section of cloth and lift. As soon as the cloth shows oil, fold it to a clean face. Rubbing smears the grease across a wider area and pushes it deeper into the batting, and a wide grease patch is much harder to remove than a small one.

  7. 7

    Rinse with warm water only.

    Wipe the area with a cloth wrung out in clean warm water, then blot dry. Repeat twice. Soap left in the fabric continues to attract dust, and on a light-colored pillow that shows up as a gray shadow within a week.

  8. 8

    Dry flat with air moving.

    Lay the cover or the whole pillow flat on a drying rack with a fan nearby, and turn it once halfway through. Hanging a damp pillow by one corner stretches it out of shape. Skip the dryer for anything with a foam or feather insert, since heat can shrink the cover and clump the filling.

What to Avoid

  • Hot water on the first pass. Heat can set the oil into the fiber and yellow light fabrics, making the mark harder to lift than it was.
  • Rubbing the grease with a dry cloth. Friction spreads the oil and pushes it into the batting, where it reappears through the cover.
  • Overloading the wash with detergent. Excess soap traps soil and leaves a stiff, dull finish that looks dirtier than before.
  • High heat in the dryer. It shrinks covers, melts synthetic trim and can bake residual oil into the fabric.
  • Bleach on a colored or patterned pillow. Dye loss is uneven and usually shows up along the seams first.

Daily Care Tips

  • Wash removable covers monthly on a gentle cycle with a small amount of mild detergent.
  • Keep hands and hair products off decorative pillows; body oil is the most common grease source.
  • Rotate pillows and fluff inserts weekly so they wear evenly.
  • Treat food and lotion marks the same day, before the oil oxidizes and turns yellow.
  • Air pillows in shade rather than direct sun, which fades the cover and can make foam brittle.

Frequently Asked Questions

What if I do not have cornstarch?

Baking soda works nearly as well and is already in most kitchens. Talcum-free baby powder and plain flour are also absorbent. Whatever you use, brush it off completely before applying any liquid, or it will turn into a paste that is harder to rinse out of the weave.

Can an old grease stain still be removed?

Often, but it takes more than one cycle. Oxidized oil darkens and bonds to the fiber over time. Alternate the cornstarch step and the dish soap foam, letting the pillow dry between attempts, and give each pass time to work. A stain that has been through a hot dryer several times may be set for good.

Can I machine wash the whole pillow?

Only if the care label says so and the insert is polyester fiberfill. Feather and down inserts need professional cleaning or a very careful hand wash, and foam inserts should not be machine washed at all. When in doubt, wash the cover and spot clean the insert.

Why does the grease come back after a few days?

Some of the oil stayed in the batting and migrated back to the surface as the cover dried. It is the same wicking effect seen on carpet. Repeat the absorb and foam steps, and this time dry the pillow flat with good airflow so the oil has nowhere to travel.

Final Thoughts

Absorb the oil with cornstarch, lift it with dish soap foam, rinse the soap out and dry the pillow flat, and the grease leaves without a ring behind.

Related guides